orders over $79
Learn moreDescription:
EHEIM thermocontrol+ e is their first adjustable heater with digital control via WLAN. You can set the precise temperature from 18 to 32 °C via smartphone, tablet or PC/MAC.
Intelligent and ingeniously designed, EHEIM thermocontrol+ e, EHIEM offer you the aquarium heater of the future!
The selected temperature is accurately measured electronically and kept constant. However, if the temperature deviates by ± 2 °C, you will be notified immediately by e-mail. Automatic synchronisation with filter activity or lighting is also possible, this means you can wirelessly connect to the EHEIM professionel 5e Filter or to the LEDcontrol+.
Key Benefits:
- Electronic aquarium heater with integrated WLAN function and digital control via smartphone, tablet or PC/MAC.
- Precise temperature setting from 18 to 32 °C
- Control accuracy ± 0,5 °C
- Indicator lights show heating function and operating status
- Notification to stored e-mail address as soon as the temperature deviates by ± 2 °C
- Smart linking with other electronically controlled devices of the EHEIM.digital family
- Synchronisation: temperature water flow adjustment or for lowering the set temperature at night, etc.) If necessary, adjustment with external thermometer (expert mode)
- Waterproof (IPX8) - for optimum wifi signal reception, immerse the heater in water up to the mark
- Dry-run protection (Thermo Safety Control)
- Convenient cable length of approx. 170 cm
- Double suction holder included
- Suitable for both fresh and marine water
- Highest safety and reliability with a 3 year guarantee.
- Multiple sizes available 150-300W to suit a variety of aquariums.
Size Guide:
- 150W = 200 - 300L
- 200W = 300 - 400L
- 300W = 600 - 1000L
Wattage indication is a guide only. Always monitor for consistent aquarium temperature using an aquarium thermometer, sold separately.
If temperature does not hold constant even temperatures, consider increasing wattage of heater. In large aquariums multiple lower wattage heaters may be used at each end to ensure optimum balanced temperatures.
Seasonal temperature changes or cold houses may cause temperature fluctuations.
Directions:
- Clean and rinse heater before use
- Monitor temperatures using an appropriate aquarium thermometer
- Never place a hot heater directly into water, (risk of breakage)
- Check heater regularly for any signs of damage
- Monitor temperatures using an appropriate aquarium thermometer
- For full set up instructions, please refer to the instruction booklet included
- Always disconnect the heaters power supply prior to working on the aquarium
- If removing the heater from the aquarium, turn it off at the power supply, wait 10-15 minutes to allow it to cool and then remove it from the aquarium
- The heater should not come in contact with the gravel or substrate